Introduction - Fujitsu MB904 Series Application Note

0 Introduction

The MB2147-05 emulator system is a low cost emulator system which can be used for
Fujitsu 16-Bit microcontrollers of the 16L/16LX Series. This application note should give a
short guideline how to install an MB2147-05 emulation system. This guide describes on the
one side the hardware installation configuration and shows on the other side how to install
and configure the corresponding software development environment to allow users a quick
start-up.
This guide does not replace the Hardware Manual of MB2147-05. This guide is giving
just a short introduction how to set-up and configure the emulator system
environment. For more detailed information please check the corresponding hardware
manual of MB2147-05.
Note
There may exist restrictions in supporting some microcontroller series, so please check first
whether the used microcontroller evaluation chip can be supported by MB2147-05. Currently
the MB2147-05 can only support evaluation chips based on 0.5Em technology:
MB906xx, MB905xx, MB90385, MB90420, MB90425, MB90435, MB90440,
MB90455, MB90460, MB90470, MB90495
The following series are not supported by this low cost emulation system:
MB90340, MB90350, MB90390, MB90480
© Fujitsu Microelectronics Europe GmbH
Change odd page title here
Introduction
- 5 - MCU-AN-390077-E-V11