Huawei AISU User Manual page 34

AISU
User Manual
Step 2 In the parameter input area, specify related parameters.
The parameter values in the following figure are for reference only.
Step 3 Press F9 or click Exec.
If Operation succeeded is displayed in the command export area, the AISU software is
loaded successfully. If the AISU software fails to be loaded, identify causes and load the
AISU software again.
----End
Querying the AISU Version Information
You can run the DSP ALDVER command to query the AISU version information, including
the device type, SN, software version, hardware version, and protocol version.
Procedure
Step 1 In the parameter input area, enter DSP ALDVER in Command (F5), and then click Assist or
press Enter.
Step 2 In the parameter input area, specify related parameters.
The parameter values in the following figure are for reference only.
Step 3 Press F9 or click Exec.
Issue 02 (2017-06-12)

Operate Mode indicates the method of loading ALD software commands. This parameter can be set
to CTRLPORT, SITE, or DEVICENO. Set this parameter to a proper value based on different
operation modes.

It is recommended that this parameter be set to DEVICENO, not to SITE.

After saving the software to the FTP server, specify the IP address, user name, password, and file
path of the server, the system will download configuration data and software from the FTP server.
 Enter a valid FTP server IP address in FTP Server IP.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
5 Configuration Guide
29