Aisu Configurations - Huawei AISU User Manual

AISU
User Manual
Before configuring the AISU, ensure that the AISU is securely installed and understand the
AISU networking mode.

5.1.1 AISU Configurations

Turning on the AISU Power Switch
You can run the MOD RETPORT command to turn on the RRU power switch and set the
current alarm threshold if the AISU is connected to the RET port of the RRU directly or over
the external RCU or RET port of the EasyRET antenna.
You can run the MOD ANTENNAPORT command to turn on the RRU power switch and set
the current alarm threshold if the AISG port of the AISU is connected to the RRU RF port
over the SBT, or RET port of the EasyRET antenna in TDD mode.
This section describes how to turn on the power switch to the AISU when the AISU is directly
connected to the RRU over the AISG cable.
Procedure
Step 1 In the parameter input area, enter MOD RETPORT in Command (F5), and then click Assist
or press Enter.
Step 2 In the parameter input area, specify related parameters.
The parameter values in the following figure are for reference only.
Issue 02 (2017-06-12)
NOTE

This document describes how to run MML commands only for DBS3900 LTE
V100R007C00SPC170. The maintenance terminal UI, MML commands, and operating mode vary
slightly depending on the eNodeB version.
 For details about MML commands and maintenance terminal operations, see the help information
about the related maintenance terminal.
 This document describes how to configure the AISU only by entering commands in Command
Input(F5).
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
5 Configuration Guide
20