Advertisement
5
Installing the Hydraulic Hoses
for the Boom-Lift Cylinders
Parts needed for this procedure:
1
Male quick-connect coupler
1
Female quick-connect coupler
1
Hydraulic hose (3/8 x 61 inches)
1
Hydraulic hose (3/8 x 79 inches)
2
Cable tie
2
Tube-clamp half
1
Flange-head bolt (5/16 x 1-1/2 inches)
Assembling the Quick-Disconnect
Fittings to the Hoses
Note: Ensure that the tank skid is raised and that the
cylinder lock is in place.
Note: Ensure that the center boom section is installed; refer
to the Installation Instructions for the sprayer.
1. Assemble the male quick-connect coupler onto the
male hose fitting
(Figure
x 79 inches).
Figure 10
1. Hydraulic hose (3/8 x 79
inches)
2. Hydraulic hose (3/8 x 61
inches)
3. Male hose fitting
10) of the hydraulic hose (3/8
4. Female quick-connect
coupler
5. Male quick-connect
coupler
2. Assemble the female quick-connect coupler onto the
male hose fitting
x 61 inches).
3. Torque the quick disconnect fitting and the hose to 24
to 30 N∙m (18 to 22 ft-lb)
Routing the Hydraulic Hoses
1. At the boom-lift manifold, note the tank hydraulic hose
at port-T and the pressure hydraulic hose at port-P of
the manifold
(Figure
1. Boom-lift manifold
2. Hydraulic hose—tank
(port-T fitting)
2. Route the hydraulic hose (3/8 x 79 inches) and the
hydraulic hose (3/8 x 61 inches) along the left frame
channel of the machine as shown in
Note: You will secure the hoses in later a later step.
6
(Figure
10) of the hydraulic hose (3/8
11).
Figure 11
3. Hydraulic hose—pressure
(port-P fitting)
4. Front of the machine
Figure 12
Advertisement
