Advertisement
Figure 2
1. Flange nut—1/2 inch (2)
2. Hydraulic motor
3. Motor bracket
3. Attach the anti-rotation bracket to the motor bracket
with a flange head bolt (5/16 x 3 inches), a flat washer,
2 compression springs, and a flange locknut (5/16
inch) as shown in
Figure
Note: Torque the nut until 2 threads of the bolt
extend beyond the end of the nut.
Note: Ensure that the bottom of the locknut is flush
with the end of the spring.
Figure 3
1. Flange-head bolt (5/16 x 3
inches)
2. Flat washer
3. Anti-rotation bracket
4. Shaft guard
5. Flange-head bolt—1/2 x
1-1/2 inches (2)
3.
4. Compression springs
5. Flange locknut (5/16 inch)
Assembling the Fittings and Hoses to
the Hydraulic Motor
1. Install a straight hydraulic fitting (5/8 inch) onto the
port-A of the hydraulic motor and a straight hydraulic
fitting (5/8 inch) onto the port-B of the hydraulic
motor
(Figure
4).
Note: Torque the fittings to 79 to 98 N∙m (58 to 72
ft-lb).
1. Straight-hydraulic
fittings—7/8 inch (2)
2. Port-A (hydraulic-motor
case)
2. Mark the straight end of 1 hydraulic hose (1/2 x 17
inch) with a piece of tape
1. Hydraulic hose (1/2 x 17
inch)
2. Tape marker (hydraulic
hose—port-A)
3. Assemble the 90-degree fitting of the marked hydraulic
hose onto the straight fitting in port-A of the hydraulic
motor
(Figure
5).
3
Figure 4
3. Port-B (hydraulic-motor
case)
4. Hydraulic motor
(Figure
5).
Figure 5
3. Straight-hydraulic fitting
(port-A)
4. Straight-hydraulic fitting
(port-B)
Advertisement
