Pingtimeout; Plm - Fujitsu FLM 150 ADM Maintenance And Trouble Clearing

Maintenance and Trouble Clearing
FJTU-320-515-480
3.54

PINGTIMEOUT

Table 3-52: PINGTIMEOUT (Ping Request Timed Out)—Transient Condition
AID Type
COM
3.55

PLM

Table 3-53: PLM (Payload Label Mismatch)—Alarm Event
AID
Direction
Type
STS1
RCV
VT
150 ADM
OC-3/
OC-12
DROPPED
SIGNAL
Issue 9, May 1999
Direction Probable Cause
NA No IP connection to
destination node or
improper IP
provisioning
Probable Cause
Incoming payload label does not
match expected payload label.
FNC and FNC Customer Use Only
3.54: PINGTIMEOUT
Suggested Corrective Action
Verify LCN physical connection from
source to destination node. Verify IP
provisioning at destination node.
Suggested Corrective Action
• The provisioning of the near-end expected
cross-connects does not agree with the
provisioning of far-end payload label.
Correct the provisioning that is in error.
Do not change expected trace based only
on the basis of the incoming trace value.
This would defeat the purpose of this
feature.
• If a cross-connect error is suspected in a
ring configuration, manually switch the
channel to the other direction. If the PLM
clears, check the cross-connects in the
suspect direction.
Vol. ll, Page 480.3-33