Toro 136-0457 Installation Instructions Manual page 3

2
Installing the Foam-Marker
Compressor on the Bracket
Parts needed for this procedure:
1 Bracket
4 Bolt (5/16 x 1 inch)
4 Washer (3/8 inch)
4 Nut (5/16 inch)
1 Foam marker (sold separately)
Procedure
Install the foam-marker compressor onto the bracket as
shown in Figure 1.
1. Bolts (5/16 x 1 inch)
2. Washer (3/8 inch)
Figure 1
3. Nuts (5/16 inch)
3
Installing the Compressor and
Bracket on the Machine
Parts needed for this procedure:
1 Carriage bolt
1 U-bolt
3 Flange nuts (3/8 inch)
1 Spacer
1 R-clamp
Procedure
1. Loosen the bolt on the top of the strap and place the
carriage bolt through the strap of the sprayer tank belt
(Figure 2).
g200499
1. Carriage bolt
2. Slide the spacer onto the bolt and place the bracket
onto the bolt as shown in
3. Put the pump suction hose through the R-clamp
(Figure 3).
4. Secure the R-clamp to the bolt with a nut
3
Figure 2
2. Spacer
Figure 2.
(Figure
g200500
3).