NO.
name
○
16
wire diameter
○
17
gas
fuse (8A)
○
18
wire feeding
motor
power source
○
19
switch
※ 【 Deepen 】 function is an optional software package. The test welding can last for 3 hours
1
after setting P menu (
Distributor to activate the function.
Note 1. The welding material, welding wire diameter and welding gas being set in ( ○ 15)~
( ○ 17)should be in line with the actual operational conditions.
2. If there is no welding data in welding material, welding wire diameter and welding gas, it
shows "--- ---", as shown in the picture below.
Names and functions
● select welding wire diameter to be used
・OP1 reserved for special design.
● welding method select. please prepare gas according to the requirement
listed below: ・CO2: CO2 gas 100%
・MAG: Ar gas 80%+CO2 gas 20%
・MIG: Ar gas 98%+O2 gas 2% or Ar gas 97.5%+CO2 gas 2.5%
・OP1, OP2, OP3 and OP4 are reserved for special design.
●protection on the wire feeding motor
Note: be sure to turn off the power source switch before replacing the
fuse.
● switch the power source ON and OFF
Section 5.4). If you desire to continue this function, please contact the
2
- - -
- - -
15
description
5