Installation; Transportation; Installation Site; Power Supply Equipment - Panasonic YD-350GL4 Operating Instructions Manual

3. Installation
3.1 Transportation
3.2 Installation site
CAUTION
In case that the product gets wet with rain or water spray:
Make sure that persons who well understand this product should check the inside of the product and wipe up water
if any. Such water entered inside the product may cause the product to malfunction.
Indoors, not subject to direct sunlight or rain, with less
●
moisture and dust.
Ambient temperature: -10
●
Maintain an appropriate distance of 20 cm or more from
●
any wall or other devices.
Maintain an appropriate distance of 30 cm or more
●
between power sources installed side-by-side.
(Install this product in the horizontal position.)
Places where the welding arc area is not subject to
●
wind. (Protect the area from wind by a partition, etc.)
Places where the product is not likely to take in metallic
●
foreign substances
3.3 Power supply equipment
CAUTION
Input voltage
Input protective devices
(Breaker, fuse etc.)
Cable cross section area
for input cable and ground wire

Installation

When hanging this product for transportation, hang it at two eyebolts.
Do not lift the product on your own.
●
As this product is heavy, it is dangerous to lift it on your own. Involve plural number of
persons with its lifting.
Do not leave the product on a slope. (The product is provided with casters.)
●
When pushing this product for transportation, do not make a sharp turn, or casters
●
or floor may be damaged.
This product is designed for indoor use only.
Do not install it in any places subject to rain or water spray.
to 40
℃ ℃
Observe the following to prevent burnout, destruction of parts and unstable
arc.
380 VAC(YD-350GL4and YD-500GL4)
Type and capacity to be applied should conform to all national
and local codes.
Type and size of cables to be applied should conform to all
national and local codes.
7
Note
When the product, which is installed on the floor, is too low
to operate, customers are required to prepare a table to
mount it. (And, in that case, provide such a table with a flange,
etc. so that the product does not slip down from the table.)