Panasonic YD-350GL4 Operating Instructions Manual page 18

NO. name
○
7
Jog-dial
manual wire
○
8
feeding button
○
9 switching button
○
10 gas check button
○
11 lock button
mode select
○
12
button
○
13 welding control
○
14 welding method
○
15
material
Names and functions
● When Mode selection key ○
description in ○ 6 )
・ When key ○ 6 selects different options, please adjust corrosponding set
value according different items.
・ During welding, the contents in ○
" initial " and " crater " current change not be changed.
●When Mode selection key ○
・ Refer to detailed description.
●When Mode selection key ○
・ select Call channel number. (Only the channel number being recorded
in ○
can be shown. )
5
●When Mode selection key ○
・ Record channel number is select.
●The function is used to feed welding wire into the liner before welding
by holding this key.
・ manual wire feeding speed is decided by the welding current.
●To switch the setting among" initial ", " Weld ", " crater " current.
・For crater OFF, it can not be switched. Only the setting for " Weld "
current can be selected.
● It is to check shield gas and adjust flow rate.
• Normally, the indicator lamp is off. The lamp is on while checking gas.
• To perform the gas check, press this button and then release, then the gas
valve of the wire feeder is turned ON and then turned OFF in 20 seconds.
Press this button once again to terminate the gas check immediately.
● During stand-by, long press button for 1 second to lock the panel. Then
all buttons on the panel expect ○
wire feeder potentiometer can be adjusted.
● Weld: welding condition setting for ○
for wire feeding check, gas check for welding,
・F. Adj: fine adjustment on F. Adj menu (
・ Call: To call the welding condition being recorded (
・ Record: To record the present welding conditions (
●For welding control method selection, (
・ crater OFF: regular welding.
・ crater ON: regular welding ～ crater welding.
・ initial ON: initial welding ～regular welding ～ crater welding.
・ spot welding: The welding lasts certain seconds according to the spot
welding time being set. The welding stops automatically when the spot
welding time is up.
●To select the welding method
・ pulse OFF: No pulse during welding.
・ pulse ON: pulse is turned on during welding.
・ root welding: NO pulse root welding
・ Deepen: NO pulse deep penetration
● select the material to be welded
・OP1 and OP2 are reserved for special design.
14
description
is set to" Weld ", (please refer to the
12
can be adjusted. However,
8
is set to "F. Adj", (
12
is set to " Call ",
12
is set to " Record ",
12
○ ○ ○ ○
can NOT be operated but the
3 6 8 9 10
～○ , ○
2 7 9
○
1 1 for panel lock
Section 5.4).
Chapter 8 )
※
1.
※
1.
Section 5.4)
and ○ ～○ , ○ ○
13 17 8 10
Section 5.4).
Section 5.4).