Installation - Siemens FDCL221 Technical Manual

5.2 Installation

007063_h_en_--
Mounting with mounting hole
1
Figure 8: Mounting hole in FDCL221
1 Mounting hole with Ø 4.4 mm
Use a screw to secure the line separator onto a plane surface or use a cable tie to
secure to a grid.
See also
2 U-rail TS35 [➙ 17]
● Specialist electrical engineering knowledge is required for installation.
● Only an expert is permitted to carry out installation work.
Incorrect installation can take safety devices out of operation unbeknown to a
layperson.
Note the positive and negative poles.
Only connect one wire per terminal. This is the only way to ensure the connection
is failure-free for the entire service life of the device.
The connection diagram shows the electrical connection for the FDCL221 line
separator in the FDnet/C-NET using terminal blocks or micro terminals.
1
2
Linie
3
Figure 9: FDCL221 connection diagram
1 Sub-stub
2 FDnet/C-NET detector line
See also
2 Shielded cable [➙ 25]
Mounting / Installation
1
2
3
3 Terminal blocks or micro terminals
5
Installation
23 | 32