Table of Contents
Advertisement
Using the Manual Watering Function
The Manual function enable of all stations (in sequence) or individual
station(s) to be manually operated at any time. Manual operation lasts
for a specified number of minutes and starts immediately, whether or
not the current day is a scheduled watering day. Only one station can
be on at a time when operating manually.
Manually Operate Specific Stations
1.
urn the Function dial to the MANUAL position. Specific Stations
T
option will be displayed by default. (See page 63 for All Stations
manual operation.)
MANUAL WATER
Specific Stations
2.
Turn the Upper Line knob to change the station number.
MANUAL WATER
00.0 Minutes
3.
Turn the Lower Line knob to select manual operating time
from 1 – 99 minutes in one-minute increments.
MANUAL WATER
10.5 Minutes
The station cycle time will count down in 10th's of a minute. The
station will shut off when the run time counts down (or is adjusted
down) to 00.0 minutes.
4.
Repeat steps 2 and 3 to select additional stations for manual
operation. Each station placed in queue will operate one at
a time in numerical sequence as the preceding station times out
and shuts off.
Note: To terminate operation, either turn the Lower Line knob to
select 00.0 run time, or turn the Function dial to the OFF position.
Pause until the station turns off (5 seconds) before changing
Function dial position.
62
STA 01
SET STA 01
NOW ON
Advertisement
Table of Contents
