Servicing The Fuses; Drive System Maintenance; Checking The Tire Pressure - Toro TimeCutter 74726 Operator's Manual

Servicing the Fuses

The electrical system is protected by fuses. It requires
no maintenance; however, if a fuse blows, check the
component/circuit for a malfunction or short.
Fuse type:
•
Main—F1 (30 A, blade-type)
•
Charge Circuit—F2 (25 A, blade-type)
1. Remove the screws securing the control panel
to the machine.
Note:
Retain all fasteners.
2. Lift the control pane up to access the main wire
harness and fuse block
3. To replace a fuse, pull out the fuse to remove
it (Figure 52).
Figure 52
1. Main (30 A)
4. Return the control panel to its original position.
Note:
Use the screws removed previously to
secure the panel to the machine.
(Figure 52).
g014921
2. Charge circuit (25 A)
Drive System
Maintenance

Checking the Tire Pressure

Service Interval: Every 25 hours—Check tire
pressure.
Maintain the air pressure in the front and rear tires as
specified. Uneven tire pressure can cause uneven
cut. Check the pressure at the valve stem
Check the tires when they are cold to get the most
accurate pressure reading.
Refer to the maximum pressure suggested by the tire
manufacturer on the sidewall of the caster wheel tires.
For machines with 42-inch or 50-inch decks, inflate
the rear drive wheel tires to 90 kPa (13 psi).
For machines with 54-inch or 60-inch decks, inflate
the front casters and rear drive wheel tires to 103 kPa
(15 psi).
1. Valve stem
46
(Figure
Figure 53
53).
g000554