Adjusting The Height Of Cut; Adjusting The Anti-Scalp Rollers - Toro TimeCutter 74726 Operator's Manual

Adjusting the Height of Cut

Note:
The transport position is the highest
height-of-cut position or cutting height at 115 mm
(4-1/2 inches) as shown in
Height of cut is controlled by the lever located to the
right of the operating position
Figure 29
Figure 29.
(Figure 29).
Adjusting the Anti-Scalp
Rollers
Machines with a 107 cm (42 inch),
127 cm (50 inch), or 137 cm (54
inch) Mower Deck Only
Whenever you change the height of cut, adjust the
height of the anti-scalp rollers.
Note:
Adjust the anti-scalp rollers so that the rollers
do not touch the ground in normal, flat mowing areas.
1. Disengage the blade-control switch (PTO), move
the motion-control levers to the N
position, and engage the parking brake.
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Adjust the anti-scalp rollers as shown in
30 to match the closest height-of-cut position.
1. Anti-scalp roller
g028025
2. Bolt
Machines with a 152 cm (60 inch)
Mower Deck Only
Whenever you change the height of cut, it is
recommended to adjust the height of the anti-scalp
rollers.
1. Disengage the blade-control switch (PTO), move
the motion-control levers to the N
position, and engage the parking brake.
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Remove the flange nut, anti-scalp roller, and bolt
from the bracket
Note:
Keep the bolt and anti-scalp roller
together when removing.
29
EUTRAL
Figure 30
3. Flange nut
4. Hole spacing
EUTRAL
(Figure 31).
-L
OCK
Figure
g010233
-L
OCK