Siemens SINUMERIK 840D sl Commissioning Manual page 1064

Backing up and restoring data
5.4 Network settings in the Service Center
Routing settings
You can make the following routing settings in the "Network settings" dialog box:
Figure 5-3
Table 5- 3 Routing settings in the "Network settings" dialog box
Settings Purpose
Add Route Add a new route.
Remove Route Delete a selected route.
Destination Specify the network destination of the route as an IP address.
Mask Subnet mask of the specified IP addresses.
Next Next hop or forwarding IP address via which the network destination can be accessed.
Interface Select an interface to which the configured IP routing applies:
Enterprise network interface X1 (Local Area Connection 2)
•
Plant network interface X2 (Local Area Connection)
•
Metric Integer cost metric (1 to 9999). Required if several routes for sending a packet to a network destination are possible in
the routing table.
62
Service Center - IP routing
Commissioning Manual, 03/2013, 6FC5397-1DP40-3BA1
PCU Base Software (IM10)