Installing and configuring updates and automation software
4.8 PCU Installer
Section
[processing_loginphase]
[processing_loginphase]
[processing_systemphase]
[processing_systemphase]
[processing_systemphase]
54
Settings
StartState=
waitTimeBetweenScanCycles
StartState=
numberOfScanCycles
waitTimeBetweenScanCycles
Description
Specifies whether the PCU Installer is active before the Desktop
boots.
The setting StartState=activated required, in particular, if
an installation requires a cold start.
Possible values:
activated PCU Installer starts setups
•
deactivated PCU Installer does not start setups
•
stopped PCU Installer is closed down
•
Specifies how long the PCU Installer waits after the setup
directories have been checked before checking them again.
Enter the waiting time in milliseconds.
In key numberOfScanCycles, you can specify how often the
setup directories will be checked.
Specifies whether the PCU Installer is active during operation of
the Desktop.
Possible values:
activated PCU Installer starts setups
•
deactivated PCU Installer does not start setups
•
stopped PCU Installer is closed down
•
You can state exceptions in section "[noactivation]."
Specifies whether and how often the setup directories check for
new setup packages.
Possible values:
•
infinite
Integer
•
You can define the waiting time between checks in key
waitTimeBetweenScanCycles.
Specifies how long the PCU Installer waits after the setup
directories have been checked before checking them again.
Enter the waiting time in milliseconds.
In key numberOfScanCycles, you can specify how often the
setup directories will be checked.
Commissioning Manual, 03/2013, 6FC5397-1DP40-3BA1
PCU Base Software (IM10)