Error Messages - W&H implantmed SI-923 Instructions For Use Manual

16. Error messages

Error no. Description
00 Electronics overheating–Safety shutdown
01 Electronics overloaded
Foot control error –
07
initializing
09 Foot control error
19 Running time limiter
99 System failure
Motor temperature too high
Motor plug-in connection
If one of the error messages described above cannot be rectified by switching off the Implantmed and then switching
it on again, the equipment must be checked by an authorized W&H service partner (see Page 52). If a total failure of
the equipment occurs caused by external circumstances, the equipment must be switched off and then on again.
Solution
Switch off device, allow device to cool for at least
10 minutes, re-start
Switch off device, allow device to cool for at least
10 minutes, re-start
Switch off device, re-start, do not actuate
foot control when switching on
Switch off device, check plug-in
connection of foot control, re-start
Switch off device and re-start
Switch off device, allow motor to cool for at least
10 minutes, re-start
Switch off device, check plug-in motor connection,
allow motor to cool for at least 10 minutes, re-start
33