Installing Your Coolbot - Store It Cold CoolBot Instruction Manual And Troubleshooting Manual

For videos and pictures about how to install your CoolBot please visit us at:
https://www.storeitcold.com/buildit
STEP 1
●
Plug the wires into the labeled ports at the bottom of your CoolBot.
●
Make sure you plug the wires in their corresponding ports according to the
description in the KNOWING YOUR COOLBOT Section (Page 3).
● Plug the wires in and out a couple times as sometimes they don't "seat" all the
way the first time.
STEP 2
●
Mount the CoolBot on the wall next to the control panel side of the A/C to make
it easier to connect the wires.
●
CAUTION! Make sure the wall fasteners are smaller in diameter than the hole
in the CoolBot tabs or you will break the plastic tabs.
STEP 3
●
Remove the air filters from the front of the A/C unit. The filters drastically
reduce cooling power. Clean your fins 2 times a month. See DIRTY FINS in
TROUBLESHOOTING GUIDE (Page 15).
●
Remove the plastic grill if you can.
● Some A/C units have a "fresh air vent" tab. This allows some mix of outside air
inside the room. If applicable, make sure it is closed.
STEP 4
● Find and free your A/C's Temperature Sensor. It's the only thing attached to
the front fins/grill of your air conditioner. On Mini Split units this sensor is often
not in front of the fins of the indoor unit. It may be tucked into a plastic cover
underneath or to the side of the unit. For pictures and examples of Mini Split
installations please visit:
●
If your A/C has a clip built into the sensor to hold the sensor in the fins, remove
the sensor from the clip and free it enough to reach the side of the A/C.
STEP 5
●
Using ONLY a 2" square piece of Aluminum foil, place the CoolBot HEATER
Cable (red tip) next to the A/C's Temperature Sensor (from step 4). Keep
together next to each other, pointing in the same direction, and wrap them
tightly with the foil (FIG 2-page 8).
●
Make sure they are away from the fins & flow of the air and hang free, not
touching anything cold or metal. You can put a wire tie or zip tie around the 2
wires (1 inch before the foil) to keep the wires from getting pulled apart.
Rev: 2017 – 11A

INSTALLING YOUR COOLBOT

www.storeitcold.com/buildit
©2017 Store It Cold, LLC 7