Changing Settings On The Coolbot; Room Temperature Setting; Fins Setting - Store It Cold CoolBot Instruction Manual And Troubleshooting Manual

CHANGING SETTINGS ON THE COOLBOT

IMPORTANT! Please make sure you are familiar with the CoolBot parts and controls as
described in the KNOWING YOUR COOLBOT (Page 3) and HOW DOES THE
COOLBOT WORK? (Page 5) sections, before making any changes to the default setup.

ROOM TEMPERATURE SETTING

This setting is the average temperature you want in your cooler.
NOTE: The factory default temperature is set at 42°F/5.6°C.
To set a new value for the Room temperature:
●
Make sure the Mode indicator light is in the Room position (Room Mode).
Press the checkmark ✓ button. The "set-temperature" will blink on the display.
●
●
Use the arrow buttons to increase or decrease the temperature.
Press the checkmark ✓ button to program (save) your new setting into
●
memory.
●
The display will go back to Room Mode showing the current room temperature.

FINS SETTING

This setting adjusts the sensitivity of the FINS Sensor to prevent freeze ups.
NOTE: The factory default setting is "1."
Adjust this setting ONLY if you are experiencing icing problems.
A higher setting is more "conservative." Some users need to bump up to "3" or "4" to
keep from icing up.
Caution! For most people, going below "0" will cause freeze-ups.
95% of CoolBot installations work well with settings in the SHADED zone.
...
SETTING
To adjust the Fins setting:
●
From the Room Mode position press the right arrow until the Mode indicator
light is in the Fins position (Fins Mode).
Press the checkmark ✓ button. The current Fin setting will blink on the Display.
●
●
Press the left/right arrow to lower/raise the setting value.
Press the ✓ button again to save your new setting into memory.
●
●
The display will go back to the Fins Mode and after 20 seconds of inactivity it
will go back to the Room Mode.
Rev: 2017 – 11A
-4 -3 -2
©2017 Store It Cold, LLC
-1 0 1
...
2 3 4
11