Oil Pressure Light - Suzuki XL7 Owner's Manual

Suzuki automobile owner's manual
Hide thumbs Also See for XL7:
Table of Contents

Advertisement

INSTRUMENT PANEL
acceleration, or stumbling on acceleration.
(These conditions may go away once the
engine is warmed up.) This will be
detected by the system and cause the light
to turn on.
If you experience one or more of these
conditions, change the fuel brand you use.
It will require at least one full tank of the
proper fuel to turn the light off.
If none of the above steps have made the
light turn off, your dealer can check the
vehicle. Your dealer has the proper test
equipment and diagnostic tools to fix any
mechanical or electrical problems that may
have developed.
Emissions Inspection and Maintenance
Programs
Some state/provincial and local govern-
ments have or may begin programs to
inspect the emission control equipment on
your vehicle. Failure to pass this inspection
could prevent you from getting a vehicle
registration.
Here are some things you need to know to
help your vehicle pass an inspection:
Your vehicle will not pass this inspection if
the check engine light is on or not working
properly.
Your vehicle will not pass this inspection if
the OBD (on-board diagnostic) system
determines that critical emission control
systems have not been completely diag-
3-23
nosed by the system. The vehicle would be
considered not ready for inspection. This
can happen if you have recently replaced
your battery or if your battery has run
down. The diagnostic system is designed
to evaluate critical emission control sys-
tems during normal driving. This may take
several days of routine driving. If you have
done this and your vehicle still does not
pass the inspection for lack of OBD system
readiness, your dealer can prepare the
vehicle for inspection.

Oil Pressure Light

If you have a low engine oil pressure prob-
lem, this light will stay on after you start
your engine, or come on when you are
driving. This indicates that your engine is
not receiving enough oil.
The engine could be low on oil, or could
have some other oil problem. Have it fixed
immediately.
The oil light could also come on in three
other situations:
• When the ignition is on but the engine is
not running, the light will come on as a
test to show you it is working, but the
light will go out when you turn the igni-
tion to START. If it does not come on with
the ignition on, you may have a problem
with the fuse or bulb. Have it fixed right
away.
• If the vehicle is idling at a stop sign, the
light may blink on and then off.
• If you make a hard stop, the light may
come on for a moment. This is normal.
WARNING
Do not keep driving if the oil pressure
is low. If you do, your engine can
become so hot that it catches fire.
You or others could be burned. Check
your oil as soon as possible and have
your vehicle serviced.
CAUTION
808235
Lack of proper engine oil mainte-
nance may damage the engine. The
repairs would not be covered by your
warranty. Always follow the mainte-
nance schedule in this manual for
changing engine oil.

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the XL7 and is the answer not in the manual?

Questions and answers

Walt
February 7, 2025

How to replace theottle bottle position sensor

1 comments:
Mr. Anderson
February 11, 2025

To replace the throttle position sensor on a Suzuki XL7:

1. Locate the throttle position sensor.
2. Push the tab on the harness and pull it free.
3. Remove the two Phillips screws securing the sensor using a Phillips bit and a ratchet.
4. Pull the old sensor off.
5. Place the new throttle position sensor in position.
6. Secure it with the two Phillips screws and tighten them.
7. Reconnect the harness.

The replacement is complete.

This answer is automatically generated

Debbie
April 6, 2025

Can this plastic shroud be taken off without causing any problems?

User image 67f2d88abdf4b
1 comments:
Mr. Anderson
April 6, 2025

The context indicates that the plastic shroud can break when touched or removed improperly. Special tools, such as an angled tool, are needed due to limited space. Care must be taken to avoid damage, so while it can be removed, improper handling may cause issues.

This answer is automatically generated

Александр
April 18, 2025

Какую жидкость заливают в тормозную систему

This manual is also suitable for:

2009 xl72007 xl7Xl7 2006

Table of Contents

Save PDF