Toro Groundsmaster 5900 Software Manual page 4

If a fault appears on the screen, press any key to view
the active fault advisory
Note:
Contact your supervisor or mechanic to relay
the fault advisory and determine the course of action.
Press the arrow keys to navigate the fault screen.
Press any key to reveal the information keys on the
screen.
Diesel-Particulate-Filter (DPF)
Maintenance Indicator
If the diesel-particulate-filter (DPF) maintenance
indicator (Figure 1) appears on the screen,
immediately contact your Toro distributor for service.
Fuel-Level Indicator
This display indicates the level of fuel in the tank
(Figure 3).
PTO Indicator
This display indicates
engaged.
Parking-Brake Indicator
This display indicates that the parking brake is
engaged (Figure 1).
Cruise-Control Indicator
This display (Figure 1) indicates when the cruise
control is set.
H/L (High/Low Range)
Speed-Range Indicator
This display indicates the selected transmission
speed range (Figure 1).
Glow-Plug Indicator
This display indicates when the engine is preheating
(Figure 1).
Engine-Hours Indicator
This display shows the total hours that the engine has
been operated (Figure
Tachometer
This display shows the engine-operating speed in
rpm (Figure 3).
(Figure 2).
(Figure 1) when the PTO is
1).
Hydraulic-Fluid-Temperature
Indicator and Cooling-Fan-Status
Indicator
This display indicates the hydraulic-fluid temperature
and the status of the cooling fan
Engine-Coolant-Temperature
Indicator and Cooling-Fan-Status
Indicator
This display indicates the engine-coolant temperature
and the status of the cooling fan
Battery Voltage
This display shows both the 12 V and 24 V battery
voltage (Figure 4).
Service-Due Indicator
This display indicates the time until the next regular
service interval.
Note:
After you service the machine, reset the
indicator.
1. Press and hold the far, right button on the
InfoCenter.
Note:
The Main Menu screen appears.
2. Select Service using the 2 buttons on the
left; press the button below the right arrow to
continue.
3. Select Hours and press the button below the
right arrow.
4. Press the button below Reset Hours.
5. Select the Hours for the appropriate next service
time and press the button below the right arrow.
Note:
A check mark appears once the indicator
has been reset.
6. When you are finished, press the button below
the exit icon (picture of an open door) to return
to the main screen, or press cancel to exit.
Audible Alarm (InfoCenter)
The alarm sounds during the following scenarios:
Lowering the deck
•
The engine is not running
•
Any deck is being lowered
Deck is out of float
•
The PTO is requested and qualified
•
Any deck is below the limit, but not floating
4
(Figure 5).
(Figure 5).