Problem Solving Guide - Miele ESW 7010 Operating And Installation Instructions

With the help of the following guide, minor faults in the performance of the
appliance, some of which may result from incorrect operation, can be remedied
without contacting Miele. This will save you time and money because you won't
need a service call.
Please note that a call-out charge will be applied to unnecessary service visits
where the problem could have been rectified as described in these operating
instructions.
Problem
The drawer does not
heat up.
A noise can be heard
when the drawer is in
use.
The food is not hot
enough.
The food is too hot.
Possible cause and remedy
The appliance is not correctly plugged in and
switched on at the mains socket.
 Insert the plug and switch on at the socket.
The circuit breaker has tripped.
 Reset the circuit breaker in the mains fuse box
(see data plate for minimum fuse rating). If, after
resetting/replacing the trip switch in the fuse box
or the residual current protection device, the
drawer will still not switch on, contact a qualified
electrician or Miele.
The noise is caused by the fan which distributes the
heat evenly throughout the drawer. This is not a fault.
The function for keeping food warm  is not
selected.
 Select the correct function.
The temperature setting is too low.
 Check that the doors have been closed properly.
 Select a higher temperature.
The vents have been covered up.
 Ensure that the air can circulate freely.
The function for keeping food warm  is not
selected.
 Select the correct function.
The temperature setting is too high.
 Select a lower temperature.

Problem solving guide

39