Connect Device Cables - Huawei IPC6061-FP Quick Start Manual

IPC6061-FP
Quick Start Guide
Figure 4-6 Assembling the dome body and the quick mounting board
----End

4.3 Connect Device Cables

l
l
l
l
Connect the Alarm Input / Output Port
Step 1 Connect alarm input device to the alarm input of I/O port.
When the input signal is idle or grounded, the device can collect the different statuses of the
alarm input port. When the input signal is connected to 3.3 V or it is idle, the device collects
the logic "1". When the input signal is grounded, the device collects the logic "0".
Issue 01 (2019-02-22)
Connect device corresponding power and audio cable well according to requirement, and
then use insulated tape to twine the connection respectively to make it waterproof.
Connect the grounding hole (
efficiently. The grounding hole is located next to the cable exit on the back of bottom
cover; the specification of ground screw is M2.5.
Connect alarm input and output terminal to external cable according to
Alarm Input / Output
waterproof.
Connect network cable to corresponding network port of the device cable according to
(Optional) Install the Waterproof
Copyright © Huawei Technologies Co., Ltd.
) to ground wire, which can improve device reliability
Port, and use insulated tape to twine connection to make it
Connector.
4 Installation
Connect the
14