Huawei IPC6061-FP Quick Start Manual page 16

IPC6061-FP
Quick Start Guide
Figure 4-5 Device installation diagram
Step 1 Take out the installation position map (shown in
the installation angle of the installation position map according to the needed monitoring
angle, and then paste it on the installation surface such as ceiling or wall and so on.
Step 2 Please dig three bottom holes on the installation surface according to the location shown in
the installation position map. It needs to dig a cable exit hole whose diameter is no less than
28 mm on the installation surface according to the location on the installation position map if
the device adopts cable wiring from the top, which makes the cable go through.
Step 3 Insert 3 expansion bolts from the accessories bag into the bottom holes and lock them firmly,
adjust the position of device installation pedestal and pull the cable through the cable exit hole
on the installation surface.
Step 4 Align 3 fixed holes of screw on the bracket with 3 plastic expansion bolt fixed holes on the
installation surface, then tighten 3 ST3 self-tapping screws into 3 plastic expansion bolts and
fasten them firmly, fix the installation chassis on the installation surface.
Step 5 When installing dome body, find the little gap on the dome body and make it align with the
"TOP" direction on the installation chassis, rotate the dome body in clockwise direction and
secure it firmly. So far, installation is completed, as shown in
Issue 01 (2019-02-22) Copyright © Huawei Technologies Co., Ltd.
Figure 4-2) from the accessories bag, adjust
Figure 4-6.
4 Installation
13