Single-Point Measurement - Cycle_974 - Siemens SINUMERIK 840D sl Programming Manual

Miscellaneous functions
7.2 Measuring cycle support in the program editor (up to measuring cycles SW 5.4)
Parameter
Parameter
_ID
_SETV[0]
_SETV[1]
_SETV[2]
_SETV[3]
_SETV[4]
_SETV[5]
_SETV[6]
_SETV[7]
_KNUM
_PRNUM
7.2.4.16

Single-point measurement - CYCLE_974

With CYCLE_974
Softkeys
CYCLE974 can be parameterized.
Parameter
Parameter
_MVAR
_SETVAL
_MA
_TNUM
_TNAME
_KNUM
_PRNUM
_STA1
7-22
Type Value Meaning
INTEGER Selection: Outside or inside corner
0...inside corner / 1...outside corner
REAL >0 Infeed path of measuring probe to measuring height, without
sign
REAL Starting position for measuring the 1st point in the 1st axis
(abscissa)
REAL Starting position for measuring the 1st point in the 2nd axis
(ordinate)
REAL Starting position for measuring the 2nd point in the 1st axis
(abscissa)
REAL Starting position for measuring the 2nd point in the 2nd axis
(ordinate)
REAL Starting position for measuring the 3rd point in the 1st axis
(abscissa)
REAL Starting position for measuring the 3rd point in the 2nd axis
(ordinate)
REAL Starting position for measuring the 4th point in the 1st axis
(abscissa)
REAL Starting position for measuring the 4th point in the 2nd axis
(ordinate)
INTEGER ≥0 ZO number
INTEGER >0 Probe number
→ →
Type Value Meaning
INTEGER ≥0 Measuring variant
REAL Setpoint
INTEGER >0 Number of measuring axis 1, 2, 3
INTEGER ≥0 Tool number for automatic offset
STRING Tool name with active tool management
INTEGER >0 Offset number
D number for measurement/ZO number for calculating zero
offset
INTEGER >0 Probe number
REAL Start angle
Programming Manual, Release 04/2006, 6FC5398-4BP10-0BA0
Measuring cycles