Siemens SINUMERIK 840D sl Programming Manual page 149

Parameters Description
DZ Infeed path at the measuring height in the Z axis (for G17)
(only for protection
zone "Yes")
DFA Measurement path
TSA Safe area for the measurement result
Other parameters and correction targets can be set in the general SD 54760$SNS_MEA_FUNCTION_MASK_PIECE.
1)
List of the result parameters
The measuring variant "Align plane" provides the following result parameters:
Table 2- 25
Parameters
_OVR [0]
_OVR [1]
_OVR [4]
_OVR [5]
_OVR [16]
_OVR [17]
_OVR [20]
_OVR [21]
_OVR [22]
_OVR [23]
_OVR [28]
_OVR [30]
_OVI [0]
_OVI [2]
_OVI [5]
_OVI [7]
_OVI [9]
_OVI [11]
Measuring cycles
Programming Manual, 02/2011, 6FC5398-4BP40-0BA0
Machine manufacturer
Please observe the machine manufacturer's instructions.
"Align plane" result parameters
Description
Angle setpoint between workpiece surface and 1st axis of the plane of
the active WCS
Angle setpoint between workpiece surface and 2nd axis of the plane of
the active WCS
Angle actual value between workpiece surface and 1st axis of the plane
of the active WCS
Angle actual value between workpiece surface and 2nd axis of the plane
of the active WCS
Angle difference around the 1st axis of the plane
Angle difference around the 2nd axis of the plane
Angle offset value
Angle offset value around the 1st axis of the plane
Angle offset value around the 2nd axis of the plane
Angle offset value around the 3rd axis of the plane
Safe area
Empirical value
WO number
Measuring cycle number
Probe number
Empirical value memory number
Alarm number
Status offset request
Measuring variants
2.3 Measure workpiece (milling)
Unit
mm
mm
mm
Unit
Degrees
Degrees
Degrees
Degrees
Degrees
Degrees
Degrees
Degrees
Degrees
Degrees
Degrees
Degrees
-
-
-
-
-
-
149