Siemens SINUMERIK 840D sl Programming Manual page 148

Measuring variants
2.3 Measure workpiece (milling)
Position after the end of the measuring cycle
The probe is at a distance of the measurement path above the last measuring point (P3).
Procedure
The part program or ShopMill program to be processed has been created and you are in the
editor.
Parameters
G code program
Parameters Description
PL Measuring plane (G17 - G19)
Calibration data set (1 - 12)
Parameters Description
Correction target


Positioning Position probe:


α Inclination of the plane to the X axis (X for G17)
L2X Distance to the 2nd measuring point in the direction of the X axis
β Inclination of the plane to the Y axis (Y for G17)
L3X Distance to the 3rd measuring point in the direction of the X axis
L3Y Distance to the 3rd measuring point in the direction of the Y axis
Protection zone Use protection zone


148
1. Press the "Meas. workpiece" softkey.
2. Press the "3D" softkey.
3. Press the "Align plane" softkey.
The input window "Measure: Align plane" is opened.
Unit
-
-
Measuring only (no offset)
Work offset (save measured values in an adjustable WO)
Parallel to the axis
Parallel to the plane
Yes
No
ShopMill program
Parameters Description
T Name of the probe
D Cutting edge number (1 - 9)
Calibration data set (1 - 12)
X Start point X of the measurement mm
Y Start point Y of the measurement mm
Z Start point Z of the measurement mm
1)
Programming Manual, 02/2011, 6FC5398-4BP40-0BA0
Unit
-
-
-
Unit
-
-
Degrees
mm
Degrees
mm
mm
-
Measuring cycles