Siemens SINUMERIK 840D sl Programming Manual page 108

Measuring variants
2.3 Measure workpiece (milling)
Parameters
G code program
Parameters Description
PL Measuring plane (G17 - G19) -
Calibration data set (1 - 12)
Parameters Description
Correction
Measuring only (no offset)

target
Work offset (save measured values in an adjustable WO)

Tool offset (save measured values in the tool data)

TR Name of tool to be corrected
D Cutting edge number of tool to be corrected
Measuring axis Measuring axis (for G17):
X

Y

W Groove width setpoint
α0 Angle between measuring axis and workpiece
Protection zone Use protection zone
Yes

No

only for protection zone "Yes":
WS Width of the protection zone
DZ Infeed distance at measuring height (for G17)
DFA Measurement path
TSA Safe area for the measurement result
Dimensional Use dimensional tolerance for tool offset (only for the "Tool offset" correction target)
tolerance
Yes

No

TUL Upper tolerance limit, workpiece (only for dimensional tolerance "Yes")
TLL Lower tolerance limit, workpiece (only for dimensional tolerance "Yes")
Other parameters and correction targets can be set in the general SD 54760 $SNS_MEA_FUNCTION_MASK_PIECE .
1)
108
ShopMill program
Unit Parameters
T
- D
X
Y
Z
Machine manufacturer
Please observe the machine manufacturer's instructions.
Description
Name of the probe
Cutting edge number (1 - 9)
Calibration data set (1 - 12)
Start point X of the measurement
Start point Y of the measurement
Start point Z of the measurement
1)
Programming Manual, 02/2011, 6FC5398-4BP40-0BA0
Unit
-
-
-
mm
mm
mm
Unit
-
-
-
-
mm
Degrees
-
mm
mm
mm
mm
-
mm
mm
Measuring cycles