R&S FSVA3000 Series User Manual page 1050

®
R&S FSVA3000/ R&S
Parameters:
<LimitLinePoints>
Manual operation:
CALCulate<n>:LIMit<li>:UPPer:MARGin <Margin>
This command defines an area around an upper limit line where limit check violations
are still tolerated.
Suffix:
<n>
<li>
Parameters:
<Margin>
Manual operation:
CALCulate<n>:LIMit<li>:UPPer:MODE <Mode>
This command selects the vertical limit line scaling.
Suffix:
<n>
<li>
Parameters:
<Mode>
Manual operation:
CALCulate<n>:LIMit<li>:UPPer:OFFSet <Offset>
This command defines an offset for a complete upper limit line.
User Manual 1178.8520.02 ─ 01
®
FSV3000
Variable number of level values.
Note that the number of vertical values has to be the same as
the number of horizontal values set with
LIMit<li>:CONTrol[:DATA]. If not, the R&S FSV/A either
adds missing values or ignores surplus values.
The unit depends on
on page 1049.
*RST:
Default unit: DBM
See " Data Points "
.
irrelevant
Limit line
numeric value
*RST:
Default unit: dB
See " Margin "
.
Window
Limit line
ABSolute
Limit line is defined by absolute physical values.
The unit is variable.
RELative
Limit line is defined by relative values related to the reference
level (dB).
*RST:
See " X-Axis "
Analyzing Measurements (Basics)
CALCulate<n>:LIMit<li>:UNIT
Limit line state is OFF
on page 479
0
on page 479
ABSolute
on page 479
Remote Commands
CALCulate<n>:
1050