Troubleshooting - Timex T2312 Manual

1. The unit does not power ON.
The unit is not connected to AC outlet, the AC outlet has no power, or is controlled by a wall switch that
is "OFF". Check AC outlet and wall switch.
2. Alarm does not come on.
The alarm time AM or PM incorrectly set, Alarm was OFF, etc. Check alarm settings.
3. Low battery indicator is on.
Batteries have not been installed correctly in the battery compartment or the batteries may be weak or
exhausted. Try replacing batteries.
4. Poor FM Radio reception on certain stations.
Weak or distant station. Try adjusting the direction of the FM wire antenna.
5. Poor AM Radio reception on certain stations.
Weak or distant station. Rotate the unit to improve reception.
6. Unit shuts "Off" unexpectedly.
The unit is in Sleep Mode instead of the power ON mode, the unit was turned ON by an alarm and the
alarm time ended, or the AC outlet unit is connected to is controlled by a wall switch that is turned
OFF. Check mode on unit. Check wall switch. Turn unit on with Power Button.
This device complies with Part 15 of the FCC Rules, operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
• Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could
void the user's authority to operate the equipment.
• NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part
15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
CAN ICES-3 (B)/NMB-3(B)

Troubleshooting

FCC Information
14