Do you have a question about the T2312 and is the answer not in the manual?
Questions and answers
Mitchel Aaronson
January 23, 2025
Th clock runs slow, is there a way to adjust so this does not happen.
1 comments:
Mr. Anderson
February 10, 2025
To prevent the Timex T2312 clock from running slow, ensure the backup battery is fresh and properly installed. If the clock is running slow on AC power, try resetting it by unplugging it for a few minutes and then setting the time again. If the issue persists, replacing the backup battery may help maintain accurate timekeeping.
This answer is automatically generated
Larry Grabowski
February 4, 2025
The volume on this radio does not increase past 20
Auto-set stereo clock radio with nature sounds and dual alarm (20 pages)
Summary of Contents for Timex T2312
Page 1
Model T2312 AM/FM DUAL ALARM CLOCK RADIO WITH battery backup For additional information, online registration, and exclusive special offers visit our website: Questions? Contact Customer Service at 1-800-888-4491...
Warranty Information ................................15 What’s in the Box This product ships with the following items. Make sure all are present. 1. T2312 Alarm Clock 2. Instruction book Product Care • Place the unit on a level surface away from sources of direct sunlight or excessive heat.
Installing and Replacing Backup Batteries Your new Timex Clock Radio includes a battery backup system that will maintain the time and alarm settings during a temporary power interruption. Press 1. Keep unit connected to AC power when changing batteries to avoid losing your settings.
Set Up Connecting to Power Source Connect the AC plug into a working wall outlet that is not controlled by a wall switch. The unit does not operate on batteries (the battery back up system maintains clock settings during power failures). AUX-IN Turning the Unit ON or OFF •...
Page 6
2 SECS PRESETS Press and hold the Clock/Presets Button until the time flashes on the display. PM indicator HOUR Press and release the Hour/ + Button to adjust the HOUR. NOTE: The PM indicator will light when the hour is set for PM. There is no AM indicator.
Setting and Using Alarms This unit has two independent alarms, Alarm 1 and Alarm 2. Each is set and operates in the same way. Instructions below show Alarm 1. Follow the same method to set Alarm 2. 2 SECS Press and hold the Alarm 1 Button until current alarm time flashes on the display. PM indicator HOUR Press and release the Hour/ + Button to adjust the HOUR.
Page 8
Press and release the Alarm 1 Button to complete alarm time setting. SELECTING YOUR ALARM SOURCE/DISARMING THE ALARM Set alarm to Buzzer Alarm set to Buzzer Set alarm to Radio Alarm set to Radio Alarm OFF Disarm alarm (no indicator) Press and release the Alarm 1 Button repeatedly as needed to cycle to desired alarm mode: Buzzer (default), Radio (last AM or FM station played) or Off (alarm is no longer active).
SNOOZE Press and release the Snooze/Sleep SNOOZE/SLEEP/DIMMER Dimmer Button when the alarm sounds to silence it for 9 minutes. Snooze can be used several times during alarm. Setting and Using the Radio BASIC RADIO OPERATION TIP: Extend FM antenna for best reception. MODE Press and release the Power/Mode/Alarm Reset Button as needed to turn unit On and select AM or FM radio band.
Page 10
PRESET RADIO SETTING AND OPERATION SETTING RADIO PRESETS This unit will store up to 20 station presets, 10 AM and 10 FM. MODE Press and release the Power/Mode/Alarm Reset Button as needed to turn unit On and select AM or FM radio band. HOUR Press and release the Hour/ + Button or Minute/ –...
MODE Press and release the Clock/Presets Button to confirm the preset number (P01 - P10) you want to assign to the current station. Continue steps 1- 5 to set all desired presets. PRESET RADIO OPERATION To listen to a preset AM or FM station at any time, press and release the Clock/Presets Button as needed to select the desired preset station.
It allows you to fall asleep while listening to the radio or a device that is connected to the Aux In Jack. NOTE: It will power off the Timex unit, but it will not power off your AUX device.
Dimmer SNOOZE/SLEEP/DIMMER Press and hold the Snooze/Sleep/Dimmer Button to toggle display brightness between high and low settings. Dimmer cannot be adjusted when alarm is sounding. Battery Cautions and Tips • Only use the recommended/supplied batteries or equivalent. • Use alkaline batteries for longer life. •...
CAUTION RISK OF ELECTRIC SHOCK. DO NOT OPEN CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO USER-SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. AVERTISSEMENT: POUR RÉDUIRE LE RISQUE D’INCENDIE OU DE CHOC ÉLECTRIQUE, NE PAS EXPOSER CET APPAREIL SOUS LA PLUIE ET L’HUMIDITÉ...
Troubleshooting 1. The unit does not power ON. The unit is not connected to AC outlet, the AC outlet has no power, or is controlled by a wall switch that is “OFF”. Check AC outlet and wall switch. 2. Alarm does not come on. The alarm time AM or PM incorrectly set, Alarm was OFF, etc.
Limited 90 Day Warranty Information Timex Audio Products, a division of SDI Technologies Inc. (hereafter referred to as SDI), warrants this product to be free from defects in workmanship and materials, under normal use and conditions, for a period of ninety (90) days from the date of original purchase.
Need help?
Do you have a question about the T2312 and is the answer not in the manual?
Questions and answers
Th clock runs slow, is there a way to adjust so this does not happen.
To prevent the Timex T2312 clock from running slow, ensure the backup battery is fresh and properly installed. If the clock is running slow on AC power, try resetting it by unplugging it for a few minutes and then setting the time again. If the issue persists, replacing the backup battery may help maintain accurate timekeeping.
This answer is automatically generated
The volume on this radio does not increase past 20