Table of Contents
Advertisement
RCL220_manual_v3-draft.doc
1
Important Information
1.1 Antenna Installation Warnings
1.
All antenna installation and servicing is to be performed by qualified technical personnel only.
When servicing the antenna, or working at distances closer than those listed below, ensure
the transmitter has been disabled.
2.
Depending upon the application and the gain of the antenna, the total composite power could
exceed 15 watts EIRP average vs. time. For fixed/mobile configuration, the distances in the
table below must be followed.
(Based upon a 4.26% Duty Cycle, 0 dB Feedline Loss)
Minimum RF Safety Distance
1.2 ESD Notice
To prevent malfunction or damage to this product, which may be caused by Electrostatic Discharge
(ESD), the radio should be properly grounded at the time of installation. In addition, the installer or
maintainer should follow proper ESD precautions, such as touching a bare metal object to dissipate
body charge, prior to touching components or connecting/disconnecting cables.
1.3 FCC Approval Notice
This device is offered as a licensed transmitter per FCC Parts 80, 90 and 95. It is approved for use
under the following conditions: Changes or modifications not expressly approved by the party
responsible for compliance will void the user's authority to operate the equipment.
Installation, operation and maintenance of the transceiver should be in accordance with the
transceiver's installation manual and applicable local, regional, and national electric codes. Tampering
or replacement with non-factory components may adversely affect the safe use of the transceiver and
may void the approvals.
1.4 FCC Part 15 Notice
This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) this device may not cause interference, and (2)
this device must accept any interference, including interference that may cause undesired operation
of the device. Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
05-XXXXA01 Version 3 Draft
Antenna Gain vs. Minimum Safety Distance
Uncontrolled Environment Exposure limits
Page 4 of 79
Fixed/Mobile Antenna Gain
0-6 dBi
6-10 dBi
0.4 meters
0.7 meters
10-16.5 dBi
1.6 meters
9/20/2016
Advertisement
Table of Contents
