GE MDS RCL220 Manual page 25

RCL220_manual_v3-draft.doc
DEVICE MODEL=220 REMOTE
DEVICE SER=<serial number printed on silver label of radio>
If any of these parameters are incorrect, you must correct them. The model and serial number
require factory or engineer login.
Frequencies are typically set by the OCU or LCU proper, but you can set J block frequencies with
the ENGFREQ command, e.g. ENGFREQ BFREQ1=221.96625 MFREQ1=220.96625.
You can verify you are running the intended firmware with the VER command:
05-XXXXA01 Version 3 Draft Page 25 of 79 9/20/2016