Com1 - GE MDS RCL220 Manual

RCL220_manual_v3-draft.doc
MOBILITY<mobility> Read Only for all users listed above.
DISABLED
ENABLED
FACTDEF=<factdef> Read Only for all users listed above. Enable means change
all configuration settings back to last saved Factory default.
DISABLED
ENABLED
FSET<fset > Read Only for all users listed above. Select special company features
set
BASIC
1
2
3
4
5
6
MAINTBAY<maintbay > Read Only for all users listed above. Maintenance Bay -
serve OTA reprogramming
DISABLED
ENABLED
CMD=<cmd> If set to 0, the command executes normally. If <cmd> is set to 1, the
command reports all settings in a format that may be copied into a configuration
script.

3.2.3 COM1

Usage: COM1 {MODE=<mode>} {BAUD=<baud>} {FORMAT=<format>} {CMD=<cmd>}
Description: Set / displays configuration of COM1.
NOTE: CMD=1 short form response command is supported.
Access Level: Administrator
Optional Arguments:
MODE=<mode> Read/Write for all users, starting at Administrator. This
immediately switches the data port among various interface modes.
05-XXXXA01 Version 3 Draft
Mobility disabled
Mobility enabled
Do not reset to factor defaults
Reset to factory defaults
Basic generic features set
Company features set #1
Company features set #2
Company features set #3
Company features set #4
Company features set #5
Company features set #6
Do not allow Maintenance Bay Mode
Allow Maintenance Bay Mode
Page 32 of 79 9/20/2016