7.1.3
Power supply X4
7.1.4
X5 and X9 load cell
7.1.5
INTERBUS-S interfaces X12, X13, X14, X15
7.1.6
Stop circuit
7.1.7
DC link voltage
1070 080 067-101 (2001.03) GB
PSI 6XXX.350 L1
see Section 7.2.
-
+24 V DC supply voltage for feeding the load cell
-
/Operate (reset signal) required before measuring event, w +2 Volt
-
analog ram force input signal, calibrated, 1 V being equivalent to 1 kN
-
shielding
Signal communication of
-
I/O signals, see Section 7.3
-
programming data
A fault in the stop circuit or the 24VDC power supply is automatically reset when cor-
rected.
The DC link voltage is permanently monitored. A fault in the DC link voltage is automati-
cally reset when it has been corrected.
Electrical connection
7-5