The two buttons have dual functions as follows: ON / OFF To switch ON press and hold for 2 seconds until 3200 appears on the display. (During this 2 seconds all the segments of the display will be actuated.) The display will then show the following sequence...
Page 3
CHANGE UNITS Quickly press and release The display will show the units currently set eg HPA. Now press to scroll through the selection of units available. When the units of choice are displayed, press to select.
Page 4
BEFORE USING THE METER FOR THE FIRST TIME: Remove the cover and fit a new battery in the battery compartment. Take great care to ensure that the battery is fitted with the correct battery polarity. Then replace the battery cover. Always check that the meter is working correctly after replacing the battery.
Page 5
MEASURING Make sure you do not exceed the meter’s operating specifications. Do not exceed the meter’s internal temperature operating range Do not put the meter on a hot surface When taking critical draft measurements always re-zero the meter in the position you are taking the readings and hold the meter still during the test.
Page 6
METER ANNUAL RECALIBRATION AND SERVICE The meter should be re-calibrated and serviced annually by a Kane approved service centre. Local regulations may require more frequent re-calibration. Calibration is performed in firmware and there are no user accessible adjustments or user serviceable parts.
If not acceptable, adjust the meter’s position to minimize interference or switch off, if possible, the offending equipment during your test. At the time of writing this manual (November 2011) Kane International Ltd are not aware of any field based situation where such interference has occurred and this advice is only given to satisfy the requirements of the Directive.
Page 8
Thank you for buying this Differential Pressure Meter. Before use, please register on our website www.kane.co.uk...
Need help?
Do you have a question about the 3200 and is the answer not in the manual?
Questions and answers