Parts Replacement/Cleaning Procedure > Consumale Parts Requiring Periodic Replacement and Cleaning Points > Removing the Inserter torque limiter (upper)
Removing the Inserter feed roller (lower)
4) Remove six screws to remove the rear transfer
1) Remove the rear cover.
(Refer to:4-9)
guide.
2) Increase the top cover open/
close angle.
(Refer to:4-9)
3) Increase the middle guide
open/close angle.
(Refer to:4-10)
Removing the Inserter torque limiter (upper)
3) Remove five screws to remove the transfer guide.
1) Remove the rear cover.
(Refer to:4-9)
2) Increase the top cover open/
close angle.
(Refer to:4-9)
4
Parts Replacement/Cleaning Procedure > Consumale Parts Requiring Periodic Replacement and Cleaning Points > Removing the Inserter torque limiter (upper)
5) Remove one spring, two resin E-rings, and two
earings to remove the pickup roller unit.
x6
F-4-37
F-4-37
x5
F-4-40
F-4-40
6) Remove three E-rings, one pickup roller, and one lever to
F-4-38
F-4-38
4) Remove three E-rings, one gear, one parallel pin, two bearings,