Settable Zero Offset - Siemens SINUMERIK 810M Operating And Programming Manual

09.91

3.1.5.1 Settable zero offset

For each axis you can select 4 variable zero offsets using "G54" to "G57".
For "G54" to "G57" there are 2 settings respectively :
• a "coarse offset" (ZO) and
• a "fine offset" of the zero points ( ADD. ZO)
Input the value for the variable zero offset into the control, as "SETTING DATA".
The entered zero point offsets are activated in the part program called.
Sequence of operation
SETTING
DATA
In any operating mode, operate the "SETTING DATA"
softkey...
ZERO-
OFFSET
... and subsequently the "ZERO OFFSET" softkey.
(( 810M))
(( Bild 19 von Druckerei
einmontieren
© Siemens AG 1990 All Rights Reserved
SINUMERIK 810M, GA3 (BN)
This input screen form appears for the
input of values for the "coarse offset"
(ZO) and "fine offset" (ADD.ZO) of the
zero points for G54 to G57.
Press the softkey for the desired
G function. The preselected G function
is indicated in the display (e.g. G 54).
6ZB5 410-0EQ02
3 Operating Sequences
3.1.5 Zero offset
3-17