Programmable Zero Offset - External Zero Offset - Siemens SINUMERIK 810M Operating And Programming Manual

09.91
3.1.5.2 Programmable zero offset
- external zero offset
a) Programmable zero offsets
The values for the G58 and G59 offsets can be written in the program.
You will find information on the programming of these zero offsets in Part 2,
"Programming", Section 2.5.
The programmed zero offset for the current part program % ... can be displayed.
Sequence of operation
Precondition:
You have selected the "AUTOMATIC" operating mode,
with the operating mode selector switch, symbol
and have called a program %:
SETTING
DATA
Now operate the "SETTING DATA" softkey...
PROG.-
ZO
... and then the "PROGRAMMABLE ZERO OFFSET" softkey.
((Bild 810M/19 einmontieren))
© Siemens AG 1990 All Rights Reserved
SINUMERIK 810M, GA3 (BN)
This display appears.
You can now read the values
for "G58" and "G59" for the X, Y, Z
axes (4th and 5th axes if present), but
you cannot change them.
6ZB5 410-0EQ02
3 Operating Sequences
3.1.5 Zero offset
3-19