Workpiece Clamping - Settable Work Offset: G54 To G59, G500, G53, G153 - Siemens SINUMERIK 802D sl Programming And Operating Manual

Programming
10.2 Positional data
10.2.10

Workpiece clamping - settable work offset: G54 to G59, G500, G53, G153

Functionality
The settable work offset specifies the position of the workpiece zero on the machine (offset
of the workpiece zero with respect to the machine zero). This offset is determined upon
clamping of the workpiece into the machine and must be entered in the corresponding data
field by the operator. The value is activated by the program by selection from six possible
groupings: G54 to G59.
Note
Workpiece clamping at an angle is possible by entering the angles of rotation around the
machine axes. These rotation portions are activated with the offset G54 to G59.
For information on operation, see Section "Setting/changing the work offset"
Programming
G54
G55
G56
G57
G58
G59
G500
G53
G153
222
; 1st Settable zero offset
; 2nd Settable zero offset
; 3rd Settable zero offset
; 4th Settable zero offset
; 5th Settable zero offset
; 6th Settable zero offset
; Settable zero offset OFF - modal
; settable zero offset OFF non-modal, also suppresses programmable offset
; As with G53; additionally suppresses base frame
Programming and Operating Manual, 11/2012, 6FC5398-5CP10-3BA0
Surface grinding