Engine And Drivetrain Break-In; Brake System Break-In; Pvt Break-In (Clutches / Belt); Standard Break-In - Polaris RZR XP TURBO S 2019 Owner's Manual For Maintenance And Safety

OPERATION

ENGINE AND DRIVETRAIN BREAK-IN

1. Fill the fuel tank with the recommended fuel. See the Refueling section for
details. Always exercise extreme caution whenever handling gasoline.
2. Check the oil level. See the Oil Check section for details. Add the
recommended oil as needed to maintain the oil level in the safe operating
range.
3. Complete the steps in the New Operator Driving Procedures section.
4. Avoid aggressive use of the brakes.
5. Vary throttle positions. Do not operate at sustained idle.
6. Perform regular checks on fluid levels, controls and areas outlined on the
daily pre-ride inspection checklist.
7. Carry only light loads.
8. During the break-in period, change both the oil and the filter at 25 hours or
one month.
9. Check fluid levels of transmission and all gearcases after the first 25 hours of
operation and every 100 hours thereafter.

BRAKE SYSTEM BREAK-IN

Apply only moderate braking force for the first 50 stops. Aggressive or overly
forceful braking when the brake system is new could damage brake pads and
rotors.

PVT BREAK-IN (CLUTCHES / BELT)

A proper break-in of the clutches and drive belt will ensure a longer life and
better performance. If a belt fails, always clean any debris from the duct and
from the engine compartment.

STANDARD BREAK-IN

Drive at slower speeds for the first 50 miles (80 km) of operation. Carry only light
loads. Avoid aggressive acceleration, high-speed operation and prolonged
operation at a specific RPM during this period.
SAND / DUNE BREAK-IN
Drive in low gear for the first 5 miles (8 km) of operation. Avoid prolonged low
speed operation at high throttle. Avoid aggressive acceleration, high-speed
operation and prolonged operation at a specific RPM during this period.
80