Driver Controls - GRAVOGRAPH L-Solution 700 User Manual

Driver controls

The Printer Driver for Windows 2000® (driver for short) has the appearance of other Windows 2000® printer drivers
(pict. 1). A thorough understanding of how Windows 2000® operates is essential to operating the driver's controls. Please
refer to your Windows 2000® manual or online help screen on how to install, operate, and troubleshoot Windows 2000®.
About of tab
This «About of» tab (pict. 1) is controlled by Windows 2000® and is present in all Windows 2000® Drivers. For information
on how to use the controls located in this tab, please refer to your Windows 2000® manual or online help screens.
The "?" in the top right corner of every tab takes you to the driver's online help screens.
By clicking on the photo of the machine it is possible to (pict. 1) :
- to load a new version of the machine program
- select bridge X installed on the machine :
first bridgeX
- select the connections installed on your machine :
- choose a storage folder for your engraving job files (JOB):
Storage folder example ("Presets Path"
- to send an engraving test file to adjust your LASER alignment :
1 - Adjust the power of your laser based on the material used for engraving the test file.
2 - Start the test file on the machine
13 lines (numbered from 0 to 12) of vertical lines are then engraved :
3 - Select the number of the best engraved line (for example line no. 6 - pict. 3 and 4)
4 - Apply (pict. 5)
5 - Confirm (pict. 5)
- to send an engraving test file to adjust your "Tickle" parameter (pict. 6):
The "Tickle" adjustment is described in the "General maintenance" chapter.
First contact
second bridge X
Serial RS232 / Parallel connections (Old machines)
USB / Parallel connections (New machines)
\L_SOLUTION\Job
) : C:
6
Printer driver
third bridge X
L-SOLUTION 700 / 800 / 900 machines . 43