NEC AP300 Installation Manual page 14

2. Open the cabinet CAREFULLY! Make sure that you shift the cover of the antenna's
carefully from the antenna's.
3. Take the antenna cover from the AP300 cover.
4. To put the antennas in vertical position, bend them carefully as shown in Figure 5.
Bend Antennas carefully into vertical position.
5. After the antennas are put in the vertical position, close the AP300 cabinet again. In
other words, put the AP300 cover back into position and secure the screws at the rear
side of the cabinet. See Figure 6. Antennas locked into Cover.
8
All rights reserved. Reproduction in whole or in part is prohibited without the written consent of the copyright owner
Figure 5. Bend Antennas carefully into vertical position.
Figure 6. Antennas locked into Cover.
AP300 Customer Engineer Manual March 2010