Risco ProSYS Plus Installation And Programming Manual page 179

Quick Keys Parameter
The same 6-digit code, which will be stored in the panel, must be entered into
the corresponding account profile created for the installation in the
Configuration Software.
If there is no match between the MS Lock code defined in the main panel and
the MS Lock code defined in the Configuration Software, the installer will
not have permission to change the following monitoring station parameters
from the Configuration Software:
MS Lock, Installer Code, MS IP Port, MS IP Address, MS Phone, Default
Enable, MS Account, MS Format, MS Channel, MS Backup, MS Enable,
Remote ID, Access Code.
Communication  Configuration SW  Call Back Phones
Quick Keys Parameter

Call Back Phones
Define three numbers that the panel can call to perform Configuration
Software (CS) communication. If no numbers have been defined, a call back
can be performed to any phone. The installer will enter a phone number
when establishing communication to the panel. If at least one number was
defined, it will be the only number that the call back can be established to.
When the CS establishes communication to the panel, it sends the panel its
calling phone number. (This number needs to be defined as My Number
under the GSM Communication menu in the CS.)
If the panel identifies one of the numbers as one of the numbers predefined
in the panel, the call will hang up and the panel will call back to that same
number.
Communication  Configuration SW  Controls
Quick Keys Parameter

Control
 
Call Back
The Call Back feature requires the system to call back to a pre-programmed
telephone number to which the alarm company's Configuration Software
computer is installed. This provides more security for remote operations
using the Configuration Software.
YES: Call Back is enabled.
NO: Call Back is disabled.
11/2017
Default
Default
Default
Yes
Page 179
Range
Range
Range
Yes/No
5IN2413 B