Configuring Dhcp Binding - Zte ZXHN H108N Maintenance Management Manual

Table 16 IPv6 DHCP Server Parameters
Parameter
LAN IP Address
Enable DHCP Server
DNS Refresh Time
2. Specify the DHCP server parameters.
3. Click Submit.

6.3.3 Configuring DHCP Binding

This procedure describes how to bind the IP address with the specified MAC address.
Prerequisite
The DHCP service is enabled.
Steps
1. On the navigation tree, click [Network→ LAN→ DHCP Binding] to open the DHCP binding
configuration page.
2. Specify the IP Address and MAC Address to bind. The following IP Address and MAC Address
are bound, see Figure
Figure 21 DHCP Binding
3. Click Add.
The DHCP binding table is configured. When the device whose MAC address is in the DHCP binding
table is connected to ZXHN H108N, it will be automatically assigned the corresponding IP address.
Description
IPv6 address of the device
Default prefix length: 64 bits
Enable the DHCP server.
The time to refresh the IPv6 address on the user side to keep
the address valid
21.
39