Configuring Operator Pages - ABB LWT300 series User Manual

Configuring Operator pages

Operator pages display relevant information about ongoing process measurements. The LWT allows
you to configure and display up to four different Operator pages. Each Operator page can display
bargraphs and/or up to three lines of data. You can scroll automatically between the four Operator
pages with the autoscroll feature (see "Enabling Operator page autoscroll" on page 40).
Operator page 1 appears by default once the LWT is powered on.
—
Figure 24 The default Operator page 1
Operator page
number
To configure an operator page:
1 Select Display > Operator Pages > Operator Page n ( n being the number of the operator page that
you want to configure).
2 From the Operator Page n screen, select Display Mode.
3 Press Edit.
4 Highlight the display mode that you want and press OK.
There are eight modes available.
5 Once the display mode is selected, press Back once to go back one screen to where you can select
the value displayed on each line/graph of the current Operator page.
The values available for display depend on the display mode. For example, if you select the
2Row 9Char display mode, the 3rd line will not be available for configuration.
6 Select the Line or Bargraph.
7 Press Edit.
8 Highlight the value that you want to display and press OK.
9 (if necessary) Repeat steps 6 through 8 to configure all remaining values.
1st line of data
2nd line of data
3rd line of data
Configuring the instrument
39