Paper Size For Esc/Pos Setting (Paper Size) - Toshiba B-EP Series Key Operation Specification

6.6.4.2.7

Paper Size for ESC/POS Setting (PAPER SIZE)

B-EP2
PAUSE
B-EP4
PAUSE
<Supplemental Explanations>
(1) When the [FEED] key is pressed, the menu moves in the opposite direction from when the
[PAUSE] key is pressed.
(2) When the [PAUSE] key is pressed while the [FEED] key is held down, or when the [POWER] key
is pressed for 3 seconds or more, the display returns to the system mode menu (ADJUST SET).
(3) When the [PAUSE] key or [FEED] key is pressed for 0.5 seconds or more during this fine
adjustment setting, repeat mode is enabled and the key pressed is repeatedly entered.
(4) The change in the fine adjustment value becomes effective when the [POWER] key is pressed
after setting, then stored in the backup memory.
(5) The factory default value is 58mm for the B-EP2 and 114mm for the B-EP4.
(6) This setting is effective only in the ESC/POS mode. There is no command to set paper width in
the ESC/POS mode. If a paper of which width is short for the print width, the print start position
may be outside of the paper. To prevent this problem, the width of paper to be loaded in the
printer must be specified.
25mm
26mm
57mm
58mm
50mm
51mm
113mm
114mm
- 109 -