X-Coordinate Fine Adjustment (X Adjust.) - Toshiba B-EP Series Key Operation Specification

6.6.4.2.2

X-coordinate Fine Adjustment (X ADJUST.)

This setting sets an amount by which the X-coordinate is shifted to the left or right.
PAUSE
<Supplemental Explanations>
(1) When the [FEED] key is pressed, the menu moves in the opposite direction from when the
[PAUSE] key is pressed.
(2) When the [PAUSE] key is pressed while the [FEED] key is held down, or when the [POWER] key
is pressed for 3 seconds or more, the display returns to the system mode menu (ADJUST SET).
(3) When the [PAUSE] key or [FEED] key is pressed for 0.5 seconds or more during this fine
adjustment setting, repeat mode is enabled and the key pressed is repeatedly entered.
(4) The change in the fine adjustment value becomes effective when the [POWER] key is pressed
after setting, then stored in the backup memory.
(5) The factory default value is +0.0mm.
(6) The X-coordinate fine adjustment setting is performed to finely shift the x-coordinate of graphic
data to the right or left. This fine adjustment is performed within the effective print width range.
(When the X-coordinate is shifted in the minus direction and reaches its origin (0), it cannot be
further shifted and stays at the origin.)
(7) This fine adjustment is disabled for self-test print (maintenance counter values, various
parameter values, and automatic self-test) and test print.
-99.9mm
-99.8mm
-0.1mm
Paper Feed
+0.0mm
Direction
+0.1mm
+99.8mm
+99.9mm
- 104 -
XYZ
– +