Error Messages And Countermeasures; Indications On The Front Panel And Countermeasures - Mitsubishi Electric CP-D70DW Operation Manual

ERROR MESSAGES AND COUNTERMEASURES

INDICATIONS ON THE FRONT PANEL AND COUNTERMEASURES

If, for some reason, printing is not possible or an error occurs during printing, the indicators on the front panel will
illuminate or blink. In this case, follow the procedure described below.
In case of an error during printing, unless you turn off the unit, the unit resumes printing automatically when the error is
corrected.
ALARM PAPER RIBBON
When the ALARM or the PAPER RIBBON indicator illuminates or blinks, open the door and carry out the above
countermeasures.
Causes and Countermeasures
POWER
This printer is in standby mode.
Connect a USB cable to the printer when not
(Orange)
connected.
It may take time that the printer is ready to print
images after the image data is sent.
The printing unit is open.
• Close the printing unit.
(Green)
A paper jam occurs.
• Refer to "Overcoming paper jams."
(Green)
The temperature of the thermal head is too high or
too low.
(Green)
• Wait until the indication goes off. When blinking
stops, the printer resumes printing automatically.
The ink ribbon which is not available to this printer
is installed.
(Green)
• Replace the ink ribbon with a new one.
The actual combination of ink ribbon and print
paper is inconsistent with the setting made by the
personal computer.
• Open the printing unit and confirm that the actual
combination of ink ribbon and print paper is
consistent with the setting made by the personal
computer. After checking, close the printing unit.
The print paper or ink ribbon is not installed.
The print paper or ink ribbon is used up.
(Green)
• Install new print paper or ink ribbon.
Other errors
(Green)
: Steady on : Off : Blinking
Page
7
7
19
7
14-15
11-12
20
17