Specification
Maximum thickness of multi-part forms:
Maximum thickness of front sheet, multi-part
forms:
Minimum thickness of single-part form:
Maximum thickness of single-part form:
Weight range for single-part forms:
For best reliability, paper grain should be in the direction that the paper is fed into the printer.
Supported documents that are flipped
The flipping of multi-part forms and short-grain single-part forms is not supported. Table 13
describes the supported flipping specifications.
Table 13. Supported flipping specifications
Specification
Minimum form length:
Maximum form length:
Minimum form width:
Maximum form width:
Paper weight:
Loading large paper rolls
You can load extra large paper rolls (up to 15 in.) below the printer to reduce how often you need
to replace the paper roll. Mounting hardware is necessary to avoid placing undue strain on the
paper feed motor. See your Toshiba representative for additional information.
Replacing the ribbon
When the print quality is not clear, it might be necessary to replace the ribbon on your printer. To
replace the ribbon:
1.
Open the ribbon door. As the door is opened, the printhead moves to a position where you
can easily load the ribbon.
42
4610 Hardware Guide for Models 2CR and 2NR
Value
0.47 mm (0.0185 in.)
0.08 mm (0.003 in.)
0.10 mm (0.004 in.)
0.2 mm (0.008 in.)
68–90 g/m
Value
80 mm (3.14 in.)
223 mm (8.78 in.)
65 mm (2.56 in.)
102 mm (4 in.)
2
75–95 g/m
2
(18–24 #)